SMR Gearbox Installation
Satisfactory functionality depends upon good installation. lubrication 
and maintenance. therefore it’s important the guidelines in the installation and maintenance leaflet. provided with every single gearbox. are followed cautiously. a few of the vital aspects of belt and torque-arm installation are listed beneath.
1. Install pulley on gearbox input shaft as shut to your reducer probable, and mount reducer on driven shaft as shut to bearing as useful. failure to perform this will likely induce excess loads from the input shaft bearings and output bearings and could bring about their premature failure.
2. Install motor and wedge belt drive together with the belt pull at somewhere around 90° on the center line in between driven and input shafts. this will likely permit tensioning in the wedge belt drive together with the torque arm which really should preferably be in stress. if output hub runs anti-clockwise. torque arm really should be positioned the right.
3. lnstall torque-arm fulcrum on the rigid help in order that the torque-arm might be at roughly proper angles on the center line through the driven shaft along with the torque arm case bolt. be sure there may be sufficient get up during the turnbuckle for belt stress adjustment.
Keep close.
Bell drive could possibly be located in any hassle-free postion. in case the torque arm is always to be applied to tighten the belts, the drive need to be at about tight angle to the line among the input and output shafts.
Bell drive could be positioned to the suitable if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown from the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted towards the correct if desired.
