Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is made solely for your modest lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has become widely utilised inside the industry of logistic units for instance minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed by the solenoid valve using the velocity managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Common Description
This energy unit is built solely for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as velocity controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the power supply is reduce, the decreasing movement is controlled by the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit 
is created exclusively to the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and also the velocity managed by a strain compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
General Description
This power unit is designed solely for that substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and the speed controlled from the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power provide is reduce, the reducing motion is controlled from the manual override perform.
Special Notes
one. This power unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned just before set up of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which must also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
four. Oil changing is required soon after the first 100 operation hours,afterwards after just about every 3000 hrs.
5. The power unit shown is made to be mounted vertically.
