Material Handling Electrical power UNIT 2
This energy unit functions energy up gravity down circuit. Activate the commence solenoid to start out the motor to lift the machine. The lowing movement is activated by the solenoid valve with all the reducing pace managed from the stress compensated movement handle valve. Goods of this series might be widely used in the sector of logistic units which include fork lift, mini lift table, and so on.
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned just before mounting the electrical power unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities, N46 hydraulic oil is proposed .
four. Oil changing is required soon after the original a hundred operation hours,afterwards when each 3000 hrs.
five. The energy unit really should be mounted horizontally.
Material Handling Power UNIT one
This energy unit is made to the fork lift market, consisting of very effective gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down motion are managed from the lever in the guide release valve, which can be equipped with an electric switch to activate the motor. The lowing velocity is controlled through the stress compensated flow management valve.
one. The duty of this energy unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean the many hydraulic components concerned prior to set up of the power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst, which need to also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is needed immediately after the initial a hundred operation hours, afterwards as soon as every 3000 hours.
five. The electrical power unit shown is designed to be mounted horizontally.